Vortex Main Section And Slide Runway Assembly Instructions - S.R.Smith VORTEX Assembly And Installation Instructions Manual

VORTEX MAIN SECTION AND SLIDE RUNWAY ASSEMBLY INSTRUCTIONS

1. Insert all five of the Branch Arms (4) into the Main Support (5). Carefully slide the arms into the
support sockets to ensure the powder coating is not damaged. Align the holes in the branch arms
with the slots in the main tube support and fasten them as shown in Figure D.
The required hardware is as follows: 1/2"–13 x 5" Hex Head Cap Screw (13), 1/2" Flat Washer (15),
1/2" Nylon Washer (19), and 1/2" Nylon Washer (19), 1/2" Flat Washer (15), 1/2" Lock Washer (16),
1/2" Hex Nut (17) on the other side of the support.
ANTI-SEIZE NEEDS TO BE USED ON ALL BOLTS, and should be applied to the threads before
attempting to place the nut on the bolt.
Note: It is important to NOT TIGHTEN the hardware at this point.
Place the column near the installation location.
FIGURE D
9