Table of Contents
Advertisement
2. Assemble the three PVC components together in the order shown in Figure FF. Do not glue any
of the parts together at this point. The plumbing system should be fully assembled first to ensure
correct orientation before the parts are glued together.
3. Slide the 1-1/2"Ø x 3" PVC Pipe (30) into the back side of the water nozzle socket in the side of
the entrance section. Then assemble the 1-1/2"Ø 45º Elbow (31) and the 1-1/2"Ø 90º Elbow (32).
4. Aim the 90º Elbow (32) toward the Main Support (5) of the slide. This is where the water supply
hose which will be run.
FIGURE FF
38
Advertisement
Table of Contents
