Table of Contents
Advertisement
14. Place the bottom outside Stair Bracket (53) in line with the two holes on the outside Stair Bracket so
that it is inside the stair bracket, as shown in Figure U.
Use the following hardware to attach the bracket to the Main Stair Support: 1/2" x 1-1/2" Hex Head
Bolt (44), 1/2" Flat Washer (15), 1/2" Nylon Washer (19), 1/2" Nylon Washer (19), 1/2" Flat Washer
(15), 1/2" Lock Washer (16), and a 1/2" Hex Nut (17).
Note: Do not fully tighten fasteners until after installing the handrails.
15. Finally, place the bottom inside Stair Bracket (54) on the outside of the previous bracket and repeat
the steps above to secure it to the stair assembly.
Note: Be sure to apply anti-seize to all fasteners to prevent galling.
FIGURE U
27
Advertisement
Table of Contents
