Table of Contents
Advertisement
Note: Before working with the flume pieces, cover the concrete with cardboard or carpet to
prevent scratching the plastic slide components.
The order of assembly is important!
All of the Runway Sections (2) are labeled at both ends indicating the order in which they need
to be assembled.
2. Assemble the Exit Flume (3) and the Runway Section (2) as shown in Figure E. Make sure that the
Runway Section (2) that you are installing is labeled B1 on one end and B2 on the other. Install the
hardware through both side rails. The required hardware is as follows: 3/8"-16 x 4" Button Head Cap
Screw S/S (11), 3/8" Flat Washer (21), 3/8" Flat Washer (21), 3/8" Lock Washer (22), 3/8" Hex Nut
S/S (23). Tighten the hardware until snug.
3. Turn the two previously connected flume parts upside down. Attach the Exit Support (6) to the Exit
Flume (3), as shown in Figure F. The required hardware is as follows: 3/8"-16 x 2" Hex Head Bolt
(7), 3/8" Flat Washer (21) on the outside and 3/8" Nylon Washer (20), 3/8" Flat Washer (21), 3/8"
Lock Washer (22), 3/8" Hex Nut (23) on the inside. Tighten the hardware until snug.
Note: Apply anti-seize to all fasteners to prevent galling.
FIGURE E
FIGURE F
10
Advertisement
Table of Contents
