Main Section Assembly - S.R.Smith TURBOTWISTER Assembly And Installation Instructions Manual

1. Place the Pedestal on the ground and set the Exit Slide Section on top as shown in Figure C.
2. Attach the Exit Slide Section to the Middle Slide Section as shown in Figure D.
If necessary lift up on the end of the exit runway in order to keep the joint tight while fastening.
Note: Ensure gasket material at the joint is intact before assembling.
The required hardware is as follows: 3/8" x 5" Socket Head Cap Screw (10), 3/8" Flat Washer (4), 3/8"
Flat Washer (4), 3/8" Lock Washer (2), 3/8" Hex Nut (1).
Note: When assembling the slide, apply a thin even coating of anti-seize to all stainless steel
fasteners. Anti-Seize aids in assembly, prevents galling, and improves corrosion resistance.
Anti-Seize can be purchased at most auto parts stores.

MAIN SECTION ASSEMBLY

Figure C
Figure D
8