Table of Contents
Advertisement
8. Place the Outside Stair Bracket (51) in line with the two holes on the inside of the Main Stair Support
Angle Bracket so that it is closest to the support tube. See Figure S.
Use the following hardware to attach the bracket to the main stair support: 1/2" x 1-1/2" Hex Head
Bolt (44), 1/2" Flat Washer (15), 1/2" Nylon Washer (19), 1/2" Nylon Washer (19), 1/2" Flat Washer
(15), 1/2" Lock Washer (16), and a 1/2" Hex Nut (17), see Figure S.
Note: Do not fully tighten fasteners until after installing the handrails.
9. Place the Inside Stair Bracket (52) on the inside of the Main Stair Support and repeat the steps to
mount it securely to the slide as shown in Figure S.
10. Add another set of side brackets and use the same hardware to fasten them. See Figure T for proper
alignment and placement.
Note: Be sure to apply anti-seize to all fasteners to prevent galling.
FIGURE S
25
Advertisement
Table of Contents
