Table of Contents
Advertisement
3. Move the ladder aside, before drilling the 1/2"Ø x 4" deep holes for the concrete anchors.
4. Move the ladder back over the holes and against the entrance section of the slide, with the HDPE
Gasket (73) between the base plate and deck. Then follow the instructions on page 41 for inserting
the concrete anchors into the deck.
The required hardware is as follows: 1/2" Concrete Anchor with hardware (9), 1/2" Nylon Washer
(19), 1/2" Lock Washer (16). For order of assembly, see Figure BB.
Note: Do not fully tighten the concrete anchors yet.
FIGURE BB
34
Advertisement
Table of Contents
