Advertisement
Quick Links
THE SWIM CLUB II
SLIDE OWNER'S MANUAL
S.R. SMITH SWIM CLUB II
FOR INSTALLATION AND USE ON INGROUND POOLS ONLY. SWIM
TM
CLUB II
FUNSLIDES
ON ABOVEGROUND POOLS, ONGROUND POOLS, HOUSEBOATS,
BOAT DOCKS, FLOATING DOCKS OR PLATFORMS.
WESTERN SALES AND MANUFACTURING PLANT
06-655
* * C A U T I O N * *
TM
FUNSLIDES
TM
ARE NEVER TO BE INSTALLED AND USED
CORPORATE HEADQUARTERS
P.O. Box 400 • 1017 SW Berg Parkway
Canby, Oregon 97013
(503) 266-2231 • (503) 266-4334
©
S.R. SMITH, LLC 2003
TM
FUNSLIDE
TM
ARE MANUFACTURED
TM
OCT
Advertisement
Related Manuals for S.R.Smith SWIM CLUB II FUNSLIDE
Summary of Contents for S.R.Smith SWIM CLUB II FUNSLIDE
- Page 1 THE SWIM CLUB II FUNSLIDE SLIDE OWNER’S MANUAL * * C A U T I O N * * S.R. SMITH SWIM CLUB II FUNSLIDES ARE MANUFACTURED FOR INSTALLATION AND USE ON INGROUND POOLS ONLY. SWIM CLUB II FUNSLIDES ARE NEVER TO BE INSTALLED AND USED ON ABOVEGROUND POOLS, ONGROUND POOLS, HOUSEBOATS, BOAT DOCKS, FLOATING DOCKS OR PLATFORMS.
- Page 2 Table of Contents Topic Page # Introduction………………………………………………………….. Applicable Standards and Codes…………………………………. Installation……………………………………………………….…… Drawings……………………………………………………………… Subsequent Owner’s………………………………………………… Manufacturer’s Placement Instructions…………………………… Installed Slide’s Structural & Installation Checklist………………. Intended Use Instructions………………………………………….. Sitting Slide Position………………………………………………… Do Not Slide Head First…………………………………………….. Daily/Weekly Maintenance Of Slide………………………………... Cleaning Instructions………………………………………………… INTRODUCTION S.R.
- Page 3 MANUFACTURER’S PLACEMENT INSTRUCTIONS The Swim Club II FunSlide owner must confirm that the Manufacturer’s Placement Instructions have been followed by the Installer. 1. The critical dimensions for placement of the slide are as shown in FIGURES I and J. A. The slide exit runway surface shall not exceed twenty inches (20”) above the water surface and not less than eight inches (8”) above the deck/coping surface.
- Page 4 extends a minimum distance of “C” from the tip end of the board. The width distance “W” on either side of Pt.C is given in CHART 1 and shown in FIGURE K. CHART 1 BOARD MINIMUM CLEARANCE AREA TYPE “C” DIMENSION “W”...
- Page 5 INSTALLED SLIDES’ STRUCTURAL & INSTALLATION CHECKLIST After installation and prior to the first use of the Swim Club II Funslide periodically thereafter the owner must: 1. Inspect the runway for visible cracks or tears. 2. Inspect the slide for sharp edges, protrusions, cracks or tears. 3.
- Page 6 5. Familiarize yourself with the shape of the pool bottom and the water depth before you slide. Use the correct slide configuration shown on the ladder when sliding. 6. Avoid sliding until all submerged obstacles, surface objects or other swimmers are clear of the slider’s pathway.
- Page 7 As a Swim Club II FunSlide owner, it is your responsibility to explain the nature of this danger to all persons who may use your Swim Club II FunSlide , since they may not otherwise appreciate the dangers of performing head first slides. FIGURE N DO NOT SLIDE HEAD FIRST DAILY/WEEKLY MAINTENANCE OF THE SWIM CLUB II...
- Page 8 CLEANING INSTRUCTIONS Use Nonabrasive soap and water when possible. In addition, you may safely use: Windex ® With Ammonia Formula 409 ® Fantastik ® Spiffits Bath Scrubfree Tackle ® Spic and Span ® Powder Calgon ® Bath Topjob ® Clorox ® Bleach Glass Plus ®...