Table of Contents
Advertisement
2. Make sure the gasket is in place. Slide all four assembled parts of the cover flume up the slide
from the bottom. You will need 3-4 people to assist in getting it positioned correctly.
Attach the hardware at the top of the runway as shown in Figure L. The hardware required for this
step is as follows: 3/8"-16 x 6" Button Head Cap Screw S/S (35), 3/8" Flat Washer S/S (18), 3/8" Flat
Washer S/S (18), 3/8" Lock Washer S/S (22), 3/8" Hex Nut S/S (23).
Next, working from the top to bottom, fasten the flumes together along the outside edge as shown in
Figure 12. The required hardware is as follows: a 3/8"-16 x 5" Button Head Cap Screw S/S (12), 3/8"
Custom Flat Washer S/S (82), 3/8" Custom Flat Washer S/S (82), 5/8" 304 SS Spacer 2 3/4" (38),
3/8" Flat Washer S/S (18), 3/8" Lock Washer S/S (22), 3/8" Hex Nut S/S (23).
Tighten the hardware until the gap in the joint is closed.
Do not over tighten.
Note: Be sure to apply anti-seize to all fasteners to prevent galling.
FIGURE L
16
Advertisement
Table of Contents
