Table of Contents
Advertisement
6. Fasten the sides of Runway Section (2) labeled B2 to the previously assembled runway section using
the fasteners shown in Figure E. Then attach the bottom of Runway Section (2) to the branch arm
using the fasteners shown in Figure G.
7. Repeat this process for the three remaining Runway Sections. Remember that order of assembly
is important. The end of each runway section is labeled and must be assembled to the runway
section with the same label.
Assembly Tip: It is recommended that Irwin Quick Grip bar clamps be used to help align the
fastener holes in the runway sections.
8. Attach the Entrance Section (1) to the last Runway Section (2). Fasten the sides of the Entrance
Section (1) as shown in Figure I. The hardware required is as follows: 3/8"-16 x 5" Button Head Cap
Screw S/S (12), 3/8" Flat Washer S/S (21), 3/8" Flat Washer S/S (21), 3/8" Lock Washer S/S (22),
3/8" Hex Nut S/S (23).
12
FIGURE I
Advertisement
Table of Contents
