S.R.Smith AQUABLAST Owner's Manual

S.R.Smith AQUABLAST Owner's Manual

Slide

Advertisement

Quick Links

TM
THE AQUABLAST
&
TM
TM
ROCKETRIDE
FUNSLIDE
SLIDE OWNER'S MANUAL
* * C A U T I O N * *
TM
TM
TM
S.R.
SMITH
AquaBlast
&
RocketRide
FUNSLIDES
ARE
MANUFACTURED FOR INSTALLATION AND USE ON RESIDENTIAL
TM
TM
INGROUND
POOLS
ONLY.
AquaBlast
&
RocketRide
TM
FUNSLIDES
ARE NEVER TO BE INSTALLED AND USED ON PUBLIC
INGROUND POOLS, ABOVEGROUND POOLS, ONGROUND POOLS,
HOUSEBOATS, BOAT DOCKS, FLOATING DOCKS OR PLATFORMS
CORPORATE HEADQUARTERS
WESTERN SALES AND MANUFACTURING PLANT
P.O. Box 400 • 1017 SW Berg Parkway
Canby, Oregon 97013
(503) 266-2231 • (503) 266-4334
EASTERN MANUFACTURING PLANT
Portland, Tennessee
www.srsmith.com
©
06-692
DEC 05
S.R. SMITH, LLC 2005

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the AQUABLAST and is the answer not in the manual?

Questions and answers

Summary of Contents for S.R.Smith AQUABLAST

  • Page 1 THE AQUABLAST & ROCKETRIDE FUNSLIDE SLIDE OWNER’S MANUAL * * C A U T I O N * * S.R. SMITH AquaBlast & RocketRide FUNSLIDES MANUFACTURED FOR INSTALLATION AND USE ON RESIDENTIAL INGROUND POOLS ONLY. AquaBlast & RocketRide FUNSLIDES ARE NEVER TO BE INSTALLED AND USED ON PUBLIC...
  • Page 2: Applicable Standards And Codes

    INTRODUCTION S.R. Smith AquaBlast & RocketRide FunSlides are manufactured for installation and use on residential inground swimming pools only. S.R. Smith AquaBlast & RocketRide FunSlides are NEVER to be installed and used on public inground pools, aboveground pools, onground pools, houseboats, boat docks, floating docks or platforms.
  • Page 3: Manufacturer's Placement Instructions

    MANUFACTURER’S PLACEMENT INSTRUCTIONS The AquaBlast & RocketRide FunSlides owner must confirm that the Manufacturer’s Placement Instructions have been followed by the Installer. 1. The critical dimensions for placement of the slide are as shown in FIGURES M and N. A. The slide exit runway surface shall not exceed twenty inches (20”) above the water surface and not less than eight inches (8”) above the deck/coping surface...
  • Page 4 CHART 1 BOARD MINIMUM CLEARANCE AREA POOL TYPE “C” DIMENSION “W” DIMENSION 14’-6” 5’-0” 14’-6” 6’-0” 16’-6” 6’-0” 18’-6” 7’-6” 21’-0” 7’-6” See Article 5 contained in ANSI/NSPI-5 2003 STANDARD FOR RESIDENTIAL INGROUND SWIMMING POOLS and refer to Figure 3 and Table 1 for Minimum Water Envelope Dimensions AB, BC and Width at Point C.
  • Page 5: Intended Use Instructions

    INSTALLED SLIDES’ STRUCTURAL & INSTALLATION CHECKLIST After installation and prior to the first use of the AquaBlast & RocketRide Funslide and periodically thereafter the owner must: 1. Inspect the runway for visible cracks or tears. 2. Inspect the slide for sharp edges, protrusions, cracks or tears.
  • Page 6 13. Do not use the slide if any part of it becomes damaged, weakened, or broken. Don’t take chances. Have the slide inspected and, if necessary, repaired by a competent professional, who is familiar with acrylic water slides before using the AquaBlast & RocketRide water slide again. See INSTALLED SLIDES’...
  • Page 7 As an AquaBlast & RocketRide FunSlide owner, it is your responsibility to explain the nature of this danger to all persons who may use your AquaBlast & RocketRide FunSlide , since they may not otherwise appreciate the dangers of performing head first slides.
  • Page 8: Cleaning Instructions

    CLEANING INSTRUCTIONS Use non-abrasive soap and water when possible. In addition, you may safely use: Windex ® With Ammonia Formula 409 ® Fantastik ® Spiffits Bath Scrubfree Tackle ® Spic and Span ® Powder Calgon ® Bath Topjob ® Clorox ® Bleach Glass Plus ®...

This manual is also suitable for:

Rocketride funslide

Table of Contents