Unknown Cause Error Messages - IGEA Cliniporator EPS02 User Manual

Cliniporator model EPS02 – User manual

Unknown cause Error Messages

7.3
The error messages reported in this section relate to unforeseeable problems and therefore cannot be
resolved by precise user action. In the presence of one of these messages, the user can restart the
device and, if the problem persists, contact the Customer Service of IGEA S.p.A.
Error message
Bad configuration data
Bad file type
Bad parity
Bad serial params
Bad serial speed
Bad stop bits
Bad word length
Cannot reinit hardware
Cannot reinit hardware. Idle
Cannot reset HW
Cannot reset HW Idle
Can't connect to FPGA server
Can't reset ECG ABORT condition
Can't test firmware integrity
Charge error in HV discharging
Charge error in invalid state
Charge Timeout. Discharging...
Charging/Discharging error
Error accessing ID repository
Error burning electrode
Error charging HV
Error delivering treatment
Error discharging
Error discharging HV
Error getting prompt
Error holding HV charge
Error in electrode recognition
Error in memory test
Error in transceiver power off/on
Error reading electrode
Error reading electrodes list
Error resetting rfid transceiver
Error selecting electrode
Error message
Error switching relays
Error updating ID repository
Firmware is corrupted
FPGA error
FPGA init error
FPGA server in idle status
Hardware in a wrong state
Hardware is in alarm
HW communications error
HW communications error. Idle
HV Failure: Overlength shutting down the machine
HW in unexpected state (state=#)
Internal error (#)
Internal/Unknown error
Invalid firmware version
No bitetag configured
No board found
No serial device configured
No serial params
Operation failed
Overlenght test failure
Power supply failure: shutting down
Power switches failure: shutting down
RFID operation error
Shutting down the machine
Switching not found
Syntax error
Timeout in switching electrodes
Unrecoverable error
Unrecoverable error Shutting down the machine
The device will be shutdown. Wait 10 sec. before
restarting the device.
Watchdog timeout elapsed: shutting down
55