IGEA Cliniporator EPS02 User Manual page 54

Error message Possible causes
The operator has approached the
RFID
electrode.
Too many tags found
The
abnormally or is damaged.
During
detected a too high current between
Treatment Failure:
the two needles during the high
HV Overload
voltage pulse delivery.
The 10 second timeout between the
Treatment timeout:
ARM pedal activation and that of the
aborted
PULSE pedal expired.
During the login, the username was
Unknown username,
not entered correctly
please retry!
The USB cable, coming from the
power part, is disconnected from the
USB driver error
relative USB port of the Panel PC.
Hardware / software problem.
The USB pen drive is not inserted or
is not inserted correctly.
USB memory key not
found or wrong
The USB pen drive is defective.
Hardware / software problem.
The
performed on an electrode already
selected for the current treatment
Warning: electrode
session.
already selected
Hardware / software problem.
54
antenna more than
RFID transponder works
treatment, the system
electrode recognition
Cliniporator model EPS02 – User manual
What to do
Repeat the recognition phase, placing a single
one
electrode near the antenna.
Contact Customer Service of IGEA S.p.A.
Check the electrode position. It is recommended to
repeat the treatment.
Press ARM again to start a new treatment.
Provide the correct credentials.
Connect the USB cable, coming from the power part,
to the USB port of the Panel PC. Then restart the
device.
Contact Customer Service of IGEA S.p.A.
Check that the USB pen drive is correctly inserted and
repeat the data export operation (for instructions on
the correct execution of the data export process see
section 5.12).
Replace the USB pen drive, then repeat the data
export operation (for instructions on the correct
execution of the data export process see section 5.12).
Contact Customer Service of IGEA S.p.A.
is
Repeat the operation with a new electrode.
Contact Customer Service of IGEA S.p.A.