Ensure That The Cleaning Device Is Depressurized - Fronius Robacta Reamer X-Line J Operating Instructions Manual

If work is required on the cleaning device while the cleaning device is being supplied with
voltage and/or compressed air:
► keep your body, especially hands, face and hair, as well as objects and all items of
► wear hearing protection
► wear protective goggles with side protection
Burning hazard due to hot cleaning cutter as a result of operation.
Before handling the cleaning cutter, allow it to cool to room temperature (+25°C, +77°F).
ensure that the To ensure that the cleaning device is depressurized, try to briefly activate the cleaning de-
cleaning device is vice without the compressed air supply. To do this, proceed as follows:
depressurized
1
2
3
66
clothing away from the cleaning cutter, cleaning motor, lifting device, gas nozzle
clamping device, wire cutter, and parting-agent injection nozzle
CAUTION!
Take protective measures:
- the cleaning cutter, lifting device, gas nozzle clamping device, wire cutter and
parting-agent injection nozzle could be activated. therefore, keep your body, es-
pecially hands, face and hair, as well as objects and all items of clothing, away
from the aforementioned parts
- wear hearing protection
- wear protective goggles with side protection
Ensure that the cleaning device is disconnected from the compressed air supply
Briefly turn the "Cleaning motor up/down" screw on the cleaning device 90° to the right
and immediately back to the starting position
- If the cleaning device does not react to the rotation of the screw, the cleaning de-
vice is depressurized
- If the cleaning device reacts to the rotation of the screw, the cleaning device is still
connected to the compressed air supply.
In this case, make sure that the cleaning device is disconnected from the com-
pressed air supply before starting any work and then ensure that the cleaning de-
vice is depressurized.