Adjusting The Position Of The Cleaning Motor - Fronius Robacta Reamer X-Line J Operating Instructions Manual

Adjusting the Position of the Cleaning Motor

Adjusting the po-
sition of the
cleaning motor
(6)
6
7
The cleaning cutter must not come into contact with the welding torch parts.
8
9
10
11
12
40
(5) (4)
Manually slide the lifting device (3) to the top lift position and hold it in this position
Manually slide the cleaning motor (4) with cleaning cutter into the cleaning position
- see detail (5) for welding torches with insulating sleeve
- see detail (6) for welding torches with spatter guard
NOTE!
Mount the cleaning motor (4) in this position in the lifting device (3) - tighten the screw
(2) on the lifting device
Perform a function test with the gas nozzle removed: Manually slide the cleaning mo-
tor into the top position
- The cleaning cutter must surround the contact tip without colliding with it.
If the cleaning cutter is in contact with welding torch parts, adjust the position of
the cleaning motor
Fit the gas nozzle onto the torch body
Perform a function test with the gas nozzle fitted: Manually slide the cleaning motor
into the top position
- The cleaning cutter must plunge into the gas nozzle without colliding with it.
If the cleaning cutter is in contact with welding torch parts, adjust the position of
the cleaning motor
Mount the protective cover on the cleaning device so that it is in its original position
Remove protective cover (1)
1
Remove the gas nozzle from the torch
2
body
Loosen the screw (2) on the lifting de-
3
vice
Make sure that the lifting device (3) is
4
(1)
in the bottom lift position
Position the welding torch in the clea-
5
ning position (approx. 1 - 2 mm/0.039 -
0.079 in. over the protective cover,
(2)
central to the cleaning motor)
(3)