Safety - Fronius Robacta Reamer X-Line J Operating Instructions Manual

Safety

Safety Please follow the safety rules below during all the tasks described in the "Installation and
Commissioning" chapter.
Incorrect operation and incorrectly performed work can cause serious injury and
damage to property.
All work listed in these Operating Instructions may only be performed by trained specialist
personnel. All functions described in these Operating Instructions may only be used by
trained specialist personnel. All work and functions specified must only be performed and
used once the following documents have been read and understood in full:
► These Operating Instructions
► All Operating Instructions for system components, especially the safety rules
Machines that start automatically can cause serious injury and damage.
In addition to these Operating Instructions, the safety regulations of the robot manufacturer
and welding system manufacturer must be followed. For your personal safety, make sure
that all protective measures have been taken in the robot's operating area and remain in
effect while you are in this area.
Danger of serious injuries due to:
► moving mechanical parts
► flying debris (chips, etc.)
► compressed air/parting agent mixture discharged from the parting-agent injection noz-
► Before starting work on the cleaning device or the associated system components:
► disconnect the customer's compressed air and power supply from the cleaning device
► make sure that the cleaning device is depressurized - the necessary steps are provid-
If the cleaning device is being supplied with voltage and/or compressed air, the fol-
lowing could cause serious injury:
► the rotating cleaning cutter
► the cleaning motor that moves up and down
► the gas nozzle clamping device that moves in and out
► activated wire cutter
► flying debris (chips, etc.)
► compressed air/parting agent mixture discharged from the parting-agent injection noz-
WARNING!
WARNING!
WARNING!
zle
and the associated system components and make sure that the compressed air and
power supply remain disconnected until all work has been completed
ed in the "Ensure that the cleaning device is depressurized" section below
WARNING!
zle
31