Service, Maintenance And Disposal; General; Before Every Start-Up; Daily - Fronius Robacta Reamer X-Line J Operating Instructions Manual

Service, maintenance and disposal

General

The cleaning device does not usually require maintenance. To ensure the cleaning device
remains operational over time, there are a number of care and maintenance tasks that
need to be carried out, however:
Before every -
start-up
-
-
-
-
-

Daily

NOTE!
Only use solvent-free cleaning products on the cleaning device.
-

Weekly

NOTE!
Only clean the parting agent container with cleaning products that are free of sol-
vents.
-
-

Every six months

Open the device and check the pneumatic valves to ensure
-
-
-
Whenever re- Open the device and
quired -
-

Disposal

Materials should be disposed of according to valid national and regional rules.
Check the fill level in the parting agent container and top up the parting agent container
if necessary
Check the fill level in the parting agent collecting container and drain the parting agent
collecting container if necessary
Check for wear of the cleaning cutter and replace the cleaning cutter if necessary
Drain the cleaning device's collecting container
Drain the wire cutter's collecting container, if in use
In general, you should visually inspect the cleaning device and ensure that any dam-
age is repaired immediately (before commissioning)
Remove parting agent deposits and dirt from device
Check the parting agent container and parting agent collecting container for contami-
nation and clean if necessary
Blow out the intake filter in the parting agent container from the inside out with com-
pressed air using the intake hose ("Starting Up the Parting Agent Atomizer" chapter)
no leaks
that all screws are screwed tightly in place
that all screw joints are fixed firmly in place on the pneumatic valves
blast the inside of the device clean with dry and reduced compressed air
lightly oil the guides on the lifting device's lifting cylinder
61