Manually Checking The Cleaning Device Functions; General - Fronius Robacta Reamer X-Line J Operating Instructions Manual

Manually Checking the Cleaning Device Functions

General

NOTE!
The cleaning device's functions must be manually checked before starting the au-
tomatic cleaning process.
NOTE!
To correctly check the functions, the welding torch must be in the cleaning position.
Manually check-
NOTE!
ing the cleaning
device functions
The relevant function is deactivated when the slots of the "Lifting device up/down",
"Clamp gas nozzle/cleaning motor on" and "Spray in parting agent" screws are in a
horizontal position.
1
2
Spray in parting agent function
Check the following while the function is executed:
-
After the function has been executed, check the following:
-
1
3
Spray in parting agent
Disconnect the connection between the cleaning device and the robot control
Connect the cleaning device's compressed air supply
The correct insertion depth of the gas nozzle into the parting agent injection device.
The correct insertion depth must be individually set depending on the gas nozzle
Whether the gas nozzle is adequately wetted with parting agent
1
4
Deactivate the function
47