Planmeca ProOne Installation Manual page 21

Installation Manual
Printed copies of this document are considered uncontrolled.
7535.13.Rev001 08.07.2018
Remove the wooden support frame and the styrofoam packaging.
Place the upper arm cover in position. Use the two M4x6 DIN 7984 fastening screws to
secure the cover to the frame as shown. Fasten one screw, then manually slide the C-arm
to the other side so that you can fasten the other screw.
Connect the X-ray unit to a power supply with a voltage appropriate to the unit you are
installing.
INSTALLING THE X-RAY UNIT
Upper arm cover
Upper arm frame
Planmeca ProOne 17