Mounting Accessories - Planmeca ProOne Installation Manual

3.2

Mounting accessories

Felt pads
Wall bracket
Extension plate (optional)
Screw M10x70 DIN 571
Washer ø10.5/21 DIN 125
Plastic insert ø14x70
Screw M8x50 DIN 571
Washer ø8.4/17 DIN 125
Plastic insert ø10x50
Screw M4x6 DIN 7984
Screw 4x30
Plastic insert ø6x30
Ferrite beads
Calibration block
Alignment pins
Screw M10x70 DIN 571
Washer ø10.5/21 DIN 125
Plastic insert ø14x70
Extension plate
(optional)
Installation Manual
Printed copies of this document are considered uncontrolled.
7535.13.Rev001 08.07.2018
The mounting accessories bag is inside the accessories carton.
The contents are:
PART QTY
Screw M8x50 DIN 571
Washer ø8.4/17 DIN 125
Plastic insert ø10x50
Wall bracket
8 chapter 5 "UNPACKING THE X-RAY UNIT" on page
12
1 section 6.1 "Attaching the X-ray unit to the wall" on
page 14
1
2
2
2
2 section 6.2 "Attaching the X-ray unit to the floor" on
page 15
2
2
2 chapter 6 "INSTALLING THE X-RAY UNIT" on page
14 (upper arm cover)
2 chapter 7 "INSTALLING THE EXPOSURE SWITCH"
on page 18
2
2 chapter 7 "INSTALLING THE EXPOSURE SWITCH"
on page 18 and chapter 8 "INSTALLING THE DIG-
ITAL SYSTEM" on page 22
1 Planmeca ProOne X-ray unit Technical manual
2 Planmeca ProOne X-ray unit Technical manual
Screw 4x30
Plastic insert ø6x30
Screw M4x6 DIN 7984
Calibration block
CONTENTS OF THE PACKING
REFER TO
Felt pads ø24
Ferrite bead
Alignment pin
Planmeca ProOne 9