Installation - NEC Express5800 Series User Manual

Chapter 2 Preparations

1.12.3 Installation

Install a riser card to a PCI card in the following procedure.
PCI #1A
1. Refer to steps 1 to 6 in Chapter 2 (1.3 Overview of Installation and Removal) for preparations.
2. Remove the screw securing the riser card.
Hold the both ends of the riser card and lift it
off.
3. Confirm the installation position with the reference to the table in (1.12.2 Supported cards and available
slots).
82
Important
When installing a PCI card, make sure the connector of the card fits the
connector of the riser card.
•
Note
Check the card type (low profile or full-height type) which respective riser card
supports and the type of PCI card to be installed.
•
If the battery for RAID controller is installed, refer to Chapter 2 (1.11 Extra
Battery / Flash Backup Unit for RAID Controller).
Important
When installing PCI board, be careful that the cables are not caught with the
support bar. Otherwise, PCI board might be damaged.
Support bar
Note
Be careful not to contact with other parts.
Express5800/R120e-1E User's Guide
1. Installing Internal Optional Devices
Screws