NEC Express5800 Series User Manual page 84

Chapter 2 Preparations
8. Insert the riser card into the slot on motherboard.
When connecting the card, position the terminal part
of the card to the slot on the motherboard and insert
it.
9. Secure the card with two screws you removed in Step 2. Secure the bracket with a single screw you have
removed in Step 4.
10. Continue to install or remove internal optional devices, mount and connect the server, and turn it on.
11. Make sure that no error messages are displayed on POST screen.
For details on POST error messages, refer to Chapter 3 (1. POST Error Message) in "Maintenance
Guide".
12. Start the BIOS Configuration utility on the mounted board to set up the board.
Availability or startup and operation procedure of the utility depends on board. For details, refer to the
manual that comes with the board. If a PCI card including RAID Controller and LAN card which
connects to any bootable device is added, the boot priority might be changed to the default
setting. In that case, configure the boot priority in the Boot menu of the BIOS Setup utility. For details
about the Boot menu, refer to Chapter 2 (1.2.5 Boot) in "Maintenance Guide".
84
Tips
Connect a cable between connector on HDD backplane board and RAID card
before installing the riser card to the server.
Express5800/R120e-1E User's Guide
1. Installing Internal Optional Devices