Power Supply Unit; Cold Redundant Feature - NEC Express5800 Series User Manual

Chapter 2 Preparations
1.19

Power Supply Unit

This server can contain two power supply units. The server provides a redundant power configuration that
ensures continued operation of the system in the unlikely event one of the power supply units fails.
You can select a power supply unit appropriate your system configuration. See the table below.
2.5-inch Drive Model
Model (Installed CPU)
N8101-730F (E5-2403v2)
N8101-73１F (E5-2407v2)
N8101-732F (E5-2420v2)
N8101-733F (E5-2430v2)
N8101-734F (E5-2430Lv2)
N8101-735F (E5-2440v2)
N8101-736F (E5-2470v2)
3.5-inch Drive Model
Number of CPUs
–

1.19.1 Cold Redundant Feature

The server supports the feature to optimize power efficiency as described below:
•
Cold redundant feature can run the system with optimum power efficiency by raising operating efficiency
of primary power supply unit and lowering that of redundant power supply unit in redundant power
configuration.
•
If power efficiency of power units is not optimized due to system configuration, this feature is disabled
automatically.
Cold redundant feature can be used under the following conditions:
•
Two power supply units must be installed for redundant configuration.
•
Referring to Chapter 2 (1. System BIOS) in "Maintenance Guide", change parameters as shown below,
save the settings and exit from SETUP.
Server → Power Control Configuration → Cold Redundant Mode → Enabled
Run SETUP again, and check if the status of Cold Redundant Mode shows Enabled in Server menu.
120
Additional HDD
Number of CPUs
1 CPU
Not installed
2 CPUs
1 CPU
Not installed
2 CPUs
Not installed
Additional HDD
Number of DIMM
cage
– –
Express5800/R120e-1E User's Guide
Number of DIMM
cage
– –
–
Up to 10
Installed
11 or more
– –
Up to 10
11 or more
Up to 6
7 or more
Available power
supply unit
450 W
1. Installing Internal Optional Devices
Available power
supply unit
800 W / 450 W
800 W / 450 W
800 W / 450 W
800 W
800 W / 450 W
800 W / 450 W
800 W
800 W / 450 W
800 W