Turning On The Server - NEC Express5800 Series User Manual

Chapter 3 Setup
1.

Turning on the Server

Pressing the POWER switch at the front of the server turns on the server.
Turn on the server by using the following procedure.
1. Turn on the display unit and peripheral devices.
2. Remove the front bezel.
3. Press the POWER switch at the front of the server.
The POWER LED is turned on green and after a while, the logo appears on the display unit.
Express5800/R120e-1E (2.5-inch Drive Model)
Express5800/R120e-1E (3.5-inch Drive Model)
While the logo is being displayed, the self-diagnostic program (POST) runs and diagnoses the hardware.
For details, refer to Chapter 3 (1.1.1 POST sequence).
• Wait for at least 40 seconds before turning on the server after connecting the
Tips
power cord.
• Do not power on the server before amber POWER LED is unlit.
Note
If the power cord is connected to power control system such as an Uninterruptible
Power Supply (UPS), make sure that the power control system is turned on.
Important
Do not connect or disconnect USB device while POST is running.
Express5800/R120e-1E User's Guide
1. Turning on the Server
POWER switch
POWER LED
POWER switch
POWER LED
139