NEC Express5800 Series User Manual page 85

Chapter 2 Preparations
(1)
When using the optional RAID Controller (N8103-172/173/174/)
For details, refer to the manual that comes with optional RAID Controller (N8103-172/173/174).
(2) When using the optional RAID Controller (N8103-168)
Described below are procedures for installing optional RAID Controller (N8103-168).
There are two types of battery bracket; made of metal and made of plastic.
Battery bracket made of metal:
1. Refer to steps 1 to 6 in Chapter 2 (1.3 Overview of Installation and Removal) for preparations.
2. Lift the processor duct and remove it from the server.
3. Connect the FBU control cable (600mm)
to the FBU.
•
Important
You must avoid static electricity to work with the procedure below. For
details, refer to Chapter 2 (1.2 Anti-static Measures).
•
Do not change the mode to hibernate when building a RAID System.
• When installing an optional RAID Controller, start the BIOS Setup utility, select
Note
PCI Configuration from the Advanced menu, and then make sure that the
parameter of PCI Slot xx ROM (xx is PCI slot number) is set to Enabled.
• When connecting a RAID Controller, set the boot priority to 8th or higher in the
Boot menu of the BIOS Setup utility. If the setting is 9th or lower, the
configuration menu for RAID Controllers cannot be launched.
Express5800/R120e-1E User's Guide
1. Installing Internal Optional Devices
85