Component Replacement; Safety Precautions; Access Panel Removal - Cornelius Nitropro Mini Service And Preventative Maintenance Manual

Nitropro Mini Service Manual
This section provides instructions or guidelines on replacing
the various Nitropro Mini components.
6.1 S P
AFETY RECAUTIONS
!
WARNING:
Disconnect power to the unit before servicing or replacing
electrical components. Follow all lock out/tag out procedures
established by the user. Verify all power is disconnected from
the unit before performing any work. Failure to comply could
result in serious injury, death or damage to the equipment.
!
CAUTION:
When replacing or testing electronic components, be sure to
wear a static strap connected to chassis ground. This protects
the electronic components from any static discharge while
working on the unit. (This specifically applies to handling of a
new Main PCB or an Ice‐Bank Controller module.)
6.2 A P R
CCESS ANEL EMOVAL
Follow the steps in the photos below to remove the access
panels in the required order.
NOTE: Use the hinge cover to collect the panel screws
removed.
Publication Number: 548000106SER

6.0 COMPONENT REPLACEMENT

‐ 24 ‐ © 2019, Cornelius Inc. All Rights Reserved