Mixing-Dispensing Assembly Components - Cornelius Nitropro Mini Service And Preventative Maintenance Manual

Nitropro Mini Service Manual
Figure 6‐1 ‐ Main PCB Housing Removed
6.4 M -D
IXING ISPENSING
This assembly contains multiple components that typically
must be unfastened from the baseplate (underside mount‐
ing screws) or from the upper brackets employing through‐
hole mounting.
Publication Number: 548000106SER
A C
SSEMBLY OMPONENTS
Figure 6‐2 ‐ Mixing‐Dispensing Assembly in Cabinet
Assembly Removal from Cabinet
1) In the cabinet, disconnect the air/water supply lines and
the wiring connector.
2) Pull the assembly release latch (Fig. 6‐2) forward and
then lift the assembly out of the cabinet and place it on a
bench or countertop.
3) Replace components by following the appropriate
instructions below.
‐ 26 ‐ © 2019, Cornelius Inc. All Rights Reserved