Power States; Commands And Responses - SMART Board 7000R Series Installation And Maintenance Manual

APPENDIX B
MANAGING THE DISPLAY USING RS-232

Power states

The display has six power states:
Power state Description
ON The display is in normal operating mode.
READY The screen is off, but the display is ready to turn on when the following
occurs:
l
l
l
STANDBY The screen is off, and the display is in a low power state. The display enters
READY or ON state when the following occurs:
l
l
l
UPDATEON The display is updating firmware. Do not turn off the display.
UPDATEREADY The display is updating firmware while the screen is off. Do not turn off the
display.
With the exception of get powerstate and set powerstate, commands are available only when
the display is in READY or ON power state.

Commands and responses

To access display information or to adjust display settings using the room control system, type
commands after the command prompt (>) and wait for the response from the display.
CORRECT
>get volume
volume=55
>
If you type a command that the room control system doesn't recognize, you will receive an invalid
command response.
69 smarttech.com/kb/171538
A user presses the Power button
remote control.
A user picks up a pen or the eraser.
You send the set powerstate=on command.
The proximity sensors detect people in the room.
A user presses the Power button
remote control.
You send the set powerstate=ready or set powerstate=on command.
on the convenience panel or the
on the convenience panel or the