SMART Board 7000R Series Installation And Maintenance Manual page 82

APPENDIX B
MANAGING THE DISPLAY USING RS-232
In the example below, the user used =-50 instead of -50.
INCORRECT
>set volume=-50
invalid cmd: setvolume=-50
>
NOTES
Use ASCII formatted commands.
l
Commands aren't case-sensitive and extra spacing is ignored.
l
You can use the BACKSPACE key when typing commands.
l
Review each entry carefully before you press ENTER.
l
Don't send another command until you receive the response and the next command
l
prompt.
To retrieve a setting's current value
Use a get command.
This example shows how to get the volume:
>get volume
volume=55
>
To assign a value to a setting
Use a set command.
This example sets the volume to 65:
>set volume=65
volume=65
>
70 smarttech.com/kb/171538