SMART Board 7000R Series Installation And Maintenance Manual page 4

IMPORTANT INFORMATION
Do not move or mount the display by connecting rope or wire to its handles. The display is
l
heavy, and failure of the rope, wire, or handle could lead to injury.
Use only VESA-approved mounts.
l
Disconnect all of the display's power cables from the wall outlet and seek assistance from
l
qualified service personnel if any of the following occur:
The power cable or plug is damaged
o
Liquid is spilled into the display
o
Objects fall into the display
o
The display is dropped
o
Structural damage, such as cracking, occurs
o
The display behaves unexpectedly when you follow operating instructions
o
CAUTION
Turn off the display before cleaning its screen. Otherwise, you may scramble the desktop
l
icons or inadvertently activate applications when you wipe the screen.
Avoid setting up and using the display in an area with excessive levels of dust, humidity, and
l
smoke.
Make sure an electrical socket is near the display and remains easily accessible during use.
l
The display should be used only with European TN and TT power distribution systems.
l
It is not suitable for older, IT-type power distribution systems found in some European
countries. "This system (IT-type) is widely used isolated from earth, in some installations in
France, with impedance to earth, at 230/400V, and in Norway, with voltage limiter, neutral
not distributed, at 230V line-to-line."
Contact qualified personnel if you're uncertain of the type of power system available where
you're installing the display.
The accessory slot's maximum available power is 60 W. The slot is not a limited power
l
source. To reduce the risk of fire, make sure that accessories connecting to the slot satisfy
the fire enclosure requirements of IEC 60950-1 and/or IEC 62368-1.
You must connect the USB cable that came with the display to a computer that has a USB
l
compliant interface and that bears the USB logo. In addition, the USB source computer must
be compliant with IEC 60950-1 and/or IEC 62368-1. The source computer must be CE
marked and carry safety certification marks for Canada and USA. This is for operating safety
and to avoid damage to the display.
ii smarttech.com/kb/171538