Power Supply - Craftex CX Series Manual

AVAILABILITY OF POWER
Before Installation of this machine you will need
to consider the proximity of your power supply
circuit. If available circuits do not meet the
requirements for this machine you will have to
get a new circuit installed by a licensed
electrician. Use of a licensed electrician will
minimize the risks of fire, electrocution, damage
to equipment, and will insure everything is wired
in accordance to the applicable codes and
standards.
FULL LOAD CURRENT RATING
This is the amount of Amps a machine draws
under 100% of the rated output power.
FULL LOAD RATING FOR 120V
15AMPS
The full load current is not the maximum amount
of amps the machine will draw. The machine has
potential to draw current beyond the full load
rating if it is overloaded. Overloading of the
machine for an extended period of time can
cause damage, overheating, or even fire. The risk
is higher if the machine is on an undersized
circuit. To help avoid these issues insure you are
connected to a circuit in which meets the
specified circuit requirements for this piece of
machinery.
WARNING!
Do not connect machine to power before
setup has been fully completed to avoid
risk of personal
damage.

POWER SUPPLY

injury or property
CIRCUIT REQUIREMENTS FOR
CX911 SLOW SPEED GRINDER
The CX911 has been prewired at the
factory for operation on an electrical circuit
that has a verified ground and meets the
below requirements:
Voltage:
Cycle:
Phase:
Circuit Breaker Size:
Please Note:
1. An electrical circuit includes all electrical
equipment between the breaker panel and
the machine. This is why it is important to
have the proper circuit size so it can safely
accommodate this machine under full load
for an extended period of time.
2. The circuit requirements laid out in this
manual are for a dedicated circuit in which
only one machine will be operational or
installed at a time. If you choose to connect
to a shared circuit where more than one
machine may be running at a time please
consult with a qualified electrician to insure
the circuit is properly sized for safe
operation.
PLUG AND GROUNDING
REQUIREMENTS
This machine must be grounded so that in
the event of certain malfunctions it will
reduce the chances of electrical shock by
providing a path of lesser resistance for the
electric current to travel through. For this
reason the CX911 comes with a cord
equipped with an equipment grounding wire
that leads in to the grounding prong on the
plug.
6
110V – 120V
60Hertz
Single
.15Amps