Craftex CX Series Manual page 12

Eye Shields
1.) Secure and
assemblies to the safety shield brackets using
the supplied fastening knobs M5-15 in Fig. F
below.
2.) Join the safety shield assembly and bracket to
the grinding wheel guard using a washer, lock
washer, and rear shield bracket knob M6-30.
3.) The eye shields should be properly positioned
over the grinding wheel to protect the operator
from sparks and debris that may be generated
during operation of the machine.
4.) Adjust the eye shield bracket and eye shield in
to the desired position directly above the
grinding wheel then securely tighten the knobs
to hold eye shields in place during operation.
WARNING!!!
Only use supplied eye shields and wheel
guards with this machine. Do not operate
machine without having all safety measures
in place.
fasten the safety shield
.
Permanent Mounting Instructions
Use the pre drilled mounting holes located
in the base of the CX911. Use these holes
to securely attach the CX911 Slow Speed
Grinder to a solid work surface or grinder
stand. (Mounting hardware not included)
See Fig. G below.
12