Craftex CX Series Manual page 17

Wire Wheels And Buffing Wheels
(Not included)
Wire or buffing wheel (A) can be used with
your CX911 Slow Speed Grinder. When
adding a wire or buffing wheel depending
on the thickness you may be required to
add additional spacers (not included) to
allow for the arbor hex nut (D) to firmly
tighten in place correctly. Fig. J above
shows you the correct configuration of the
spacers (B).
Note:
The spacer (B) should always go on to the
arbor shaft first followed directly by the
wheel flange (E) then the Wheel followed by
the wheel flange (E) and finally secured
with the arbor hex nut (D).
CX911 Maintenance
WARNING!!!
Before beginning any maintenance or
adjustments switch the on/off switch in to
the off position and remove the machine
from its power source.
Lubrication:
The CX911 is equipped with sealed
bearings that are located in the motor
housing and are pre lubricated. They will
not require any additional lubrication.
Cleaning:
While the machine is turned off and
removed from its power source slowly turn
the grinding wheels by hand inspecting
them for any
Occasionally blow out the area around the
grinder to keep the machine as well as the
work area tidy.
CAUTION!!!
If grinding wheels appear damaged, cracked,
or have a sizeable chip replace them
immediately. Failure to do this can result in
serious personal injury to the operator as
well as cause property damage. Occasionally
check all knobs and fasteners to insure the
are tight and secure.
WARNING!!!
Do not use flammable liquids or solvents to
clean the CX911 Slow Speed Grinder. A
clean dry solvent free rag is all that is
required to remove built up dust or debris
when cleaning your grinder.
17
damage or debris.