The Display Module; Function; Settings; Contents Of The Main Display - INTEGRA Metering CALEC energy master Installation And Operating Instructions Manual

22.3

The display module

22.3.1 Function

The display module can be fitted on the CPU module or mounted separately with the RDA set, e.g. on
a control panel. The display module consists of:
• A dot-matrix display (128 * 64 pixel) with a white backlight.
In case of a device fault or alarm, the backlight flashes red.
• Six keys
• An optical M-Bus interface (interface 2, independent of other M-Bus interfaces )
• A connector for communicating with the CPU module.
For devices with protective housings (Prot),
the protective foil is fitted on the cover, not on
the display module.

22.3.2 Settings

Setting
Language of the display text
Baud rate of the optical M-Bus interface
Contrast of the display
Segment test

22.3.3 Contents of the main display

The values shown in the main display may vary, depending on the device version or device function.
In devices with conformity assessment, this list must not be changed.
With non-EC conformity tested devices, the displayed values of the main display can be changed us-
ing the AMBUS Win II software
56
For the version without protective housing
(Mod), the display module is delivered with
protective foil
Submenu
Basic setting / system / interface 2 / language
Operating setting / interface / interface 2 / Bd
Basic setting / system / interface 2 / contr.
Main display
®
CALEC energy master installation and operating instructions