Troubleshooting; Messages; Error Message In The Main Display; Diagnosis Submenu - INTEGRA Metering CALEC energy master Installation And Operating Instructions Manual

18 Troubleshooting

18.1

Messages

Messages are triggered by the events set out in the following table.
In case of a fault or alarm, the backlight of the display will flash, and a message will appear in the
Error messages menu in the main display.
The table shows triggered events, display and actions to be taken in relation to the messages:
Event type Trigger
Error Device error
Alarm Unauthorised operating
mode
Configuration error
Calibration- Activate programming
relevant mode, change calibration
events data
Other events Change protection level
Change switching status
of an output 1)
1) User-programmed messages
18.2

Error message in the main display

If the device is in error status (flashing red backlight), the error message is accessed in the main
display by pressing the
Error messages
No error
Display during normal
operation
18.3

Diagnosis submenu

Diagnosis
Messages
Alarm / error
Log book
Calibration log
42
Entry in
Logbook
Logbook
Calibra-
tion log
Logbook
Logbook
key repeatedly.
Error message 1
error Th CPU module
Display of an error message (example). In case of several error
messages, use the
Additional information which could be useful for the operation
and the error search is shown in the Diagnosis submenu.
CALEC
Display M-Bus
red status byte
X Error
X Error
X Error
- -
- -
keys to move back and forth.
®
energy master installation and operating instructions
Action
Repair or replace device
Return to authorised op-
erating mode (self-
healing)
Change parameters or
assemble modules (cre-
ate valid configuration)
Recalibrate device
-
-