Settings; Signal Types - INTEGRA Metering CALEC energy master Installation And Operating Instructions Manual

22.4.2 Settings

The parameters of the inputs can only be set in programming mode.
In EC conformity assessed devices, changes will invalidate the calibration!
The settings for input signals in the basic setting / input submenu differ, depending on type of signal.
The values can be divided into three groups:
Input 1
Mod-No 2
T-No. 82-10-11
Signal ID Namur 200Hz
Funct. Impulse
MeaVar Volume
...
Filter Off
SC-int On
U aux 6VDC
Z Inp. 100k Ohm
Lot- no. 96370508
HW_No. 1804169
FWV V 01.00.03

22.4.3 Signal types

The table below shows the signal types and their use:
Group Signal type
Inactive
Ana- Current 0 – 20mA
logue
signals Current 4 – 20mA
Digital IB pulse 5Hz
signals IC pulse 200Hz
ID Namur 200Hz
IE pulse 10kHz
PFM 10kHz
Special
58
Main parameters
Select the input with the
Display of the module number
Display of the terminal numbers
Input signal type, see table above
Only for digital signals: Status, pulse or frequency
Information on the measured variable
Function-dependent parameters; description depends on the correspond-
ing signal type
Parameters that can only be changed with signal type = Special
Input filter ( against contact bouncing)
Short-circuit / interrupt detection
Voltage of the auxiliary supply
Input impedance
Identification details of the input module
Production batch number
Hardware version number
Firmware version number
Application
Input without function
analogue current signal
analogue current signal
slow pulse transmitter
fast pulse transmitter
NAMUR pulse transmitter
very fast pulse transmitters
or frequency transmitters
For simulation, setting of
fixed values and special
electrical characteristics
®
CALEC
keys
Comment
Current value, e.g. for flow rate, pressure
Temperature etc.
Potential free contacts, reed transmitters
Open collector, optocoupler
For transmitters with pulse-frequency-
modulation
Changes in the electrical properties of the
input. Other signal types have fixed configu-
rations
energy master installation and operating instructions