Time Settings: Date, Billing Dates, Logger Etc; Settings Of Calculator Function For Measuring Transducer - INTEGRA Metering CALEC energy master Installation And Operating Instructions Manual

17.2.5 Time settings: date, billing dates, logger etc.

The submenu Operating setting / time settings groups various settings connected to time set-
tings:
Time settings
Date/ti 30.06.08 12:34
Bil d 1 30.06.--
Bil d 2 31.12.--
Logger daily
C-Dat. 25.06.08
Valid. 1
T oper 123 h
T-Err1 2 h

17.2.6 Settings of calculator function for measuring transducer

The main settings in the Basic settings submenu are:
Menu point
Application 1
Application 2
Calculator setting 1
Calculator setting 2
Assignment table 1
Assignment table 2
®
CALEC energy master installation and operating instructions
Settable? Parameter
Yes
OK
Date and time, enter character by character
Yes Date for billing date 1 enter character by character
Yes Date for billing date 2 enter character by character
Inactive: Logger is switched off.
Yes
The logger is activated when an interval is selected: Monthly,
15 days, daily, hourly, 30 minutes, 15 minutes. The readings
of the 3 registers (E, M, V) are recorded
No If date display: 'calibration date', calibration valid
If 0 is shown: calibration invalid
No 1: Calibration valid; 0: calibration invalid
No Operating hours
No Error hours, time during which at least one error was identi-
fied
Display
Fct. Energy calculator
2: Fct. Energy calculator
Fct. Flow calculator
Wtr Water
2: Fct Flow calculator
2: Wtr Water
Fct Flow calculator
Sig Input 1
2: Fct Flow calculator
2: Sig Input 2
etc. OK
Note
Select calculator with the
Select calculator with the
Signal from flow meter 1 to pulse input 1
Signal from flow meter 2 to pulse input 2
keys
keys
41