Table of contents Contact of the organization Safety rules and precautions 2. 1. Information on the user manual relating to legal notice 2. 2. Handling, transport and storage 2. 3. Disposal rules for RUBIN® SONIC Smart Technical characteristics 3. 1. Metrological data 3.
Contact of the organization INTEGRA Metering AG Ringstrasse 75 CH-4106 Therwil Switzerland Phone: +41 61 725 11 22 info@integra-metering.com www.integra-metering.com Reproduction of these instructions or parts of them in whatever form is not permitted without express written permission from the publisher.
2. 2. Handling, transport and storage The manufacturer assumes no responsibility if the following safety instructions and instructions are followed precautionary meas- ures are not observed: Any changes made to the unit without the prior written consent of the manufacturer will result in the following leads to the immediate expiration of product liability and warranty ...
3. 2. Dimensions Dimensions Inches 2" Weight Height (H1) Total height (H) 198.5 215.5 233.5 259.5 275.5 Width (W) Housing length (L1) 3. 3. Power supply Type Lithium battery Lifetime Up to 16 years* * Depending on sending interval of radio telegram, telegram length operating temperature. Installation and checks NOTICE Notice...
Page 6
10. Check that the screen turns ON after 30 sec to 1 minute (depending on the amount of ain in the network). CAUTION Caution When the connector output is used (Pulse acquisition, M-Bus connection), the following requirements apply: The cable must be unroll. The maximal cable length is 25m. INTEGRA Metering provides adapted cables with various length. 6/13 1-320-UM-EN-03...
4. 2. Check the correct installation of RUBIN® SONIC Smart 4. 2. 1. Environment The RUBIN® SONIC Smart must not exceed extreme conditions: max 70°C / 158°F (no more than 2 weeks at 35°C / 95°F); min -20°C / -4°F (2 weeks below 0°C / 32°F). 4.
Understanding the interface RUBIN® SONIC Smart 5. 1. Understand the face plate 5. 2. Screen display information 5. 2. 1. Display sequence To show the data read by the meter in the display, various windows have been created as functions that can display the assigned system information.
5. 3. Understand the events on the screen LCD 5. 3. 1. Set LCD display symbols Name Symbol Information Instant flow is positive. Flow direction Instant flow is negative. Set when the screen is displaying the positive index (forward volume), (with or without water in the pipe).
5. 3. 2. Understanding display codes This summary shows all possible events which require attention by the user. Display codes Events Conditions Reserved Air bubbles Air is detected in the pipe. Burst A leak is detected Overload High instantaneous flow Frost Low water temperature Heat...
6. 2. Description of the RUBIN® SONIC Smart connector The RUBIN® SONIC Smart has an "M 12X5" connector, it is available in two output communication systems M-Bus or Pulse (the Pulse output is equipped with a cut cable detection alert). M-Bus communication system Pulse output communication system M 12X5 male connector Pinout...
ParamApp® Android application 7. 1. Presentation of ParamApp® ParamApp® is a powerful and user-friendly Android application developed by INTEGRA Metering dedicated to commissioning, configuration and diagnostics of smart devices or smart meters directly on site, with a smartphone and through NFC.
7. 2. Installation ParamApp® Android application ParamApp is a powerful and user-friendly software tool developed by INTEGRA metering dedicated to the commissioning, installation and configuration of smart devices or smart meters directly on site. With a full range of possibilities, you can configure and configure your live devices.