INTEGRA Metering CALEC energy master Installation And Operating Instructions Manual page 60

Digital signal 'pulse' function
The pulse function allows metering via a pulse signal
Input 1
...
Signal ID Namur 200Hz
Funct. Pulse
MeaVar Volume
Side Q Q Cold side
Status 0.000 Hz
ImpVal 1.00000 L
...
Digital signal 'frequency' function
The frequency function allows the evaluation of a frequency signal, e.g. from a flow sensor.
Input 1
...
Signal IE Imp. 10kHz
Function Frequency
MeaVar Volume-flow
Side Q Cold side
Status 0.000 Hz
V fmin 0.00 m3/h
V fmax 1000 m3/h
f min 0.000 Hz
f max 10000.0 Hz
Lco Q 0.00 %
Q Err 0.00 m3/h
...
LinFct None
The units of the measured variable correspond to those of the current value in the submenu
Basic settings / units
60
Signal type
Pulse function
Physical quantity
Sensor installation
side
Status at input
Pulse value
Note
Signal type
Measured variable
Sensor install. side
Status at input
Value at f min
Value at f max
Low cut-off value
Display in case of
error
.
Select the input with the
e.g. Class ID Namur 200Hz acc. to EN 1434
metering using pulse signals as input
Energy, volume, mass, HCA
Hot side / cold side:
Not relevant:
Frequency measured at input
Input range: 0.00001 to 999999
Units (see below)
Select the input with the
Signal type: IE up to 10 kHz. The function is not avail-
able with signal type IB Imp. 5Hz
Frequency measurement
Available measured variables: power, volume flow,
mass flow, frequency, temperature, pressure, density
Settable as: not relevant, hot side, cold side
Frequency measured at input
Value of the measured variable at f min
Value of the measured variable at f max
Lower limit of the frequency measuring range
Upper limit of the frequency measuring range
0.00 – 20.00 % of maximum flow value
This value is displayed in case of an input error, and
used for the calculation.
Parameter/function not yet implemented
®
CALEC energy master installation and operating instructions
keys
for energy measurement
for flow measurement
keys