Use Under Operating Conditions; The Main Display - INTEGRA Metering CALEC energy master Installation And Operating Instructions Manual
Hide thumbs
Also See for CALEC energy master:
Table of Contents
Advertisement
16 Use under operating conditions
16.1
The main display
Main display
ImpVal 1.00000 L
Side Q
cold side
C.-Dat.
21.04.09
Valid
31.12.13
Start
Notes:
The content of the main display depends on the device version. The main display can contain up to
four pages with up to four values (i.e. up to 16 values). In standard CALEC
vices, only three pages are displayed with the values shown above.
The display values of the main display are predefined at delivery. These values and their sequence
can be altered in a non-CE conformity assessed device using the software AMBUS Win II.
®
CALEC
energy master installation and operating instructions
After switching on the device, the page
marked 'start' of the main display ap-
pears.
The arrow keys can be used to move
between a maximum of 4 pages of the
main display:
The segment test shows a chequer-
board pattern to test the display.
In the error message window, an error
message is displayed if an error occurs
In the main menu, the submenus can
be selected and displayed to show or
set further values.
If no operation is carried out for approx.
Submenus
5 min., the device will display the main
menu page marked 'Start'.
1: Calibration-relevant data
2: Meter readings and designation
3: Current values
4: other values, if configured
Segment test (display test)
Error display
Main menu
®
energy master de-
35
Advertisement
Table of Contents
