M-Bus Address; Settings For The Calculator Function; Standard Applications; Do Not Change Settings In Programming Mode - INTEGRA Metering CALEC energy master Installation And Operating Instructions Manual

17.1.4 M-Bus address

Addressing type, i.e. collective or single address, and the M-Bus addresses (M-Bus modules and
the infrared interface according to EN60870-5) can be set in service mode
M-Bus primary and secondary address under Operating mode / M-Bus addressing:
M-Bus Addressing 1
Pri 2
Sec 1534
17.2

Settings for the calculator function

17.2.1 Standard applications

The devices are delivered with preset basic settings; when commissioning standard applications,
the following values should be set:
• Interface parameters (address, baud rate...)
• Operating settings: output signals, billing dates and logger parameters
• Individual calculator parameters: Limiting values dT and Cut alarm

17.2.2 Do not change settings in programming mode

Changing settings in programming mode is only useful in exceptional cases, and is only possible
with devices without CE conformity assessment. Please consult your customer service advisor.
Warning: Only activate programming mode if the consequences are known!
If the basic settings are faulty, the device will not function correctly, or will cease to func-
tion!
An alteration of the basic setting in conformity-assessed (calibrated) devices will invali-
date the calibration!
38
Entry Parameter
Click on
Enter primary address, 0 to 255
OK
Enter secondary address with max. 8 characters
(000 0000 to 9999 9999). At delivery, the secondary ad-
OK
dress corresponds to the serial number.
®
CALEC energy master installation and operating instructions
to select interface, from No. 4
: