Table of Contents
Advertisement
I
P
NSTALL
CAUTION:Be careful not to damage the wires on the back of the clock when hanging or removing the clock.
Installation Overview
The Primex Eco Clock comes fully assembled and sets automatically with a few easy steps.
You can start the Primex Eco Clock in a convenient central location such as a maintenance facility. However,
l
before hanging the Primex Eco Clock, verify at the clock's final location that the clock has sufficient ambient
light and network signal strength for full operations.
Before starting the Primex Eco Clock, be sure that the Primex Wireless transmitter is operating properly with
l
adequate building coverage.
During the start procedure, the Primex Eco Clock receives a signal from the Primex Wireless transmitter. Primex
l
Wireless transmitters with external antennas broadcast for only 27 minutes each hour, from 39 minutes before
the hour to 6 minutes after the following hour. If you have a transmitter with an external antenna, follow these
guidelines to efficiently start your Primex Eco Clocks.
Small quantity of Primex Eco Clocks: Start the clocks during the window in which the transmitter
l
is broadcasting.
Large quantity of Primex Eco Clocks: Power cycle (unplug and plug in) the transmitter, causing it
l
to broadcast continuously for 8 hours, during which time you can start the clocks.
Allow sufficient time to complete the full start procedure without interruption.
l
Read the entire start procedure before beginning and refer to Figure 3
l
Figure 3: Back of the Primex Eco Clock
Primex Wireless
E
C
RIMEX
CO
LOCK
XR Series Eco Clock Installation Guide
6
Advertisement
Table of Contents
