Replace Batteries - Primex XR PERSONAL SERIES Installation & User Manual

R B
EPLACE ATTERIES
The Personal Series Clock notifies the user when the batteries need to be changed by showing the "Low Battery" symbol on the clock display.
NOTE:
Review the Battery Guidelines before replacing the clock batteries.
Recommendation" located on page 7.
Complete the steps below to replace the clock batteries.
1. Remove the clock from its location to access the back of the clock.
NOTE:
If the clock is mounted using the Clock Lock feature a specific movement is required to remove the clock from its mount
location.
2. Remove the battery holder cover.
3. Remove the old batteries and wait 10 seconds.
4. Insert four alkaline C-cell batteries.
5. Replace the battery holder cover.
When the batteries are in place, the Personal Series Clock will begin its initialization sequence. All elements on the LCD display will light up
and the unit will beep once. After four seconds, dashes will appear on the display and remain until the unit's receiver locates a channel signal.
The receiver will search until a signal is found, scanning rapidly through 72MHz channels. The receiver will look for a time signal for 1 minute,
and then switch to scanning in 30- minute intervals until receiving a signal. Normal operation begins once a signal is received.
Primex Wireless
For additional information, see "Remove Clock from Clock Lock Mount" located on page 12.
XR Personal Series LCD Clock Installation & User Guide
For additional information, see "Battery Use
14