Upgrade Procedure - IBM 3745 Series Connection And Integration Manual

The following table compares the two procedures:
Upgrade Procedure
• Is disruptive at CCU level
• Control program removed
• MOSS must be alone
• Modifies the CDF to record hardware
changes when:
- Changing a
LIe
- Changing a L1C cable
- Changing a TRA cable
- Changing an HSS cable.
Update Procedure
• Is disruptive only for the concerned
scanners
• Control program remains active
• MOSS must be on-line
• Modifies the CDF to record hardware
changes when:
- Changing a L1C
- Changing a L1C cable
- Changing an HSS cable.
• Displays
LIe,
HSS, TRA, and Ethernet
LAN adapters (ELA) line parameters
and L1C information
• Modifies L1C and HSS line parameters.
For more help, refer to the CDF function in the Advanced Operations Guide,
SA33-009?
Upgrade Procedure
• If the MOSS is already
running alone
(the CCU control program is not
operational), begin at Step 8 on page 5-9.
• If the MOSS is not running alone, then you must use the reset (RST) MOSS
function to remove the control program from the CCU(s):
For a Model 410,41A, 610, or 61A, begin at Step 1.
For the other models, begin at Step ?
Step 1
@]
0 0 (
Enter
I
Step 2
Select the CCU affected.
[2J
or
0
then
B
Step
3
§]
Step 4
00~
B
If the MOSS is alone on the second CCU, go to Step 8 on page 5-9.
Otherwise, continue with the next step.
Step
5
Select the second CCU.
[2J
or
0
then
( Enter
I
Step
6
§]
Step
7
00~
B
5-8
3745 All Models
&
3746-900: CIG
o
/
'
/
'"
"'. j
0