Saving The Controller Configuration; Moss Integration Procedures - IBM 3745 Series Connection And Integration Manual

o
Saving the Controller Configuration
0
o
o
o
IBM
recommends using your BACKUP optical disk to save the current
configuration of the controller in the MOSS-E after a CDF-E update has been done.
Note: No need to save controller configuration in case of network change for the
Ethernet Bridge or the Multiaccess Enclosure.
To backup the controller configuration:
Step 1. Insert the backup optical diskette into the optical drive.
Step . 2. Double-click on the Service Processor object icon or on the Service
Step
Step
Step
Step
Step
Step
Processor Menu in the. Window List.
3. Click on
Operation Management.
4. Double-click on Manage Disks and Databases function.
5. Click on
Save Databases on Optical Disk.
6. Click on OK.
7. Follow the prompts (the active CDF-E is being copied on the hard disk
and then onto the optical disk).
8. When the save is completed, click on Cancel to exit from the function.
This operation takes about 5
minutes and does not disturb the service processor
operation.
MOSS Integration Procedures
Following are the procedures necessary to accomplish the task of integrating the
3745 base frame hardware into your network using the MOSS.
All of these procedures are explained in more detail as functions in the Advanced
Operations Guide, SA33-0097.
If you have a 3745 Model A - - - - - - - - - - - - - - - - - - ,
1. Log on the service processor
2. Open a MOSS window
Refer to the Basic Operations Guide, SA33-0177, for detailed operations
On the MOSS function screens you are often asked to press Entr. This means
press
I
Enter
J
on the service processor keyboard.
Chapter 5. Integration Procedures .
5-5