IBM 3745 Series Connection And Integration Manual page 38

o
•
o
o
o
o
Step 2
Unplugging the DCE cable for RSF
a. Unfasten the ground cable clamp. This cable clamp is fixed on the
bottom of the frame in one of the three holes .
b. Remove the cable by squeezing the levers and pulling out the plug.
If you are only unplugging the RSF cable, go to Step 4 on page 1-18.
Step 3
Plugging in the DCE cable for RSF
a. Refer to the figures of the Step 2.
b. Find the cable with a label that matches the connector.
c. Fasten the ground cable to the frame with the cable clamp. This
cable clamp is fixed on the bottom of the frame in one of the three
holes.
Note: The cable clamp serves to reduce the possibility of radio
frequency interference that might be caused by the operating
machine. Proper installation of the cable clamp is necessary to
meet FCC requirements, and to conduct electrostatic discharges
(ESDs) to ground.
d. Hold the plug of the cable with the green side lever upward,
squeeze both side levers, and push the plug strongly into the port
connector.
Chapter 1. 3745 Models 210 to 61 A: Connecting LlCs and Cables
1-17