IBM 3745 Series Connection And Integration Manual page 63

Unplugging LlC types 5 and 6 Cable(s)
Refer to the LICSI6 Migration and Integration Guide, SA33-0416 or
earlier version of the Connection and Integration Guide, SA33-0129.
If you are only unplugging a
Lie
cable, go to Step 12 on page 2-17
If you only want to plug in a LIe cable without removing a LIe, go to
Step 8.
Otherwi~e,
to remove LlC(s), continue with the next step.
Step 6
Removing LlC(s)
1. Turn the knob counterclockwise to unlock the LIe:
2. Remove the LIe by delicately pulling it out.
Repeat this step for every LIe to be removed.
If you have no LlCs to install, go to Step 9 on page 2-17
Otherwise, continue with the next step.
Step
7 Inserting LlC(s)
Repeat this step for every LIe to be inserted.
a. Touch the electrostatic discharge plate.
b. Ensure that the slot is clear. If necessary, carefully remove the
bundle of cables for this
Lie
row from behind the cable retaining
bracket.
Note: Do not forget to replace the cables behind the retaining
bracket when finished.
c. Hold the LIe so that the black plastiC side is on the left and the
knob is pointing toward you.
d. Push the
Lie
into the slot until it clicks.
e. Turn the knob clockwise to lock the
Lie
in place.
Step 8
Plugging in LIC cable(s)
Note: The cable-retaining bar and ground plate assembly at the base
of the machine may be removed to allow easier access to the cables.
Remove the two wing screws and lift it out:
--... h
•
o
If there is no raised floor, remove the retaining bar only.
2-16
3745 All Models
&
3746-900: CIG
()
o