Chapter 1. 3745 Models 210 To 61A: Connecting Lics And Cables - IBM 3745 Series Connection And Integration Manual
Communication controller/nways multiprotocol controller
Hide thumbs
Also See for 3745 Series:
- Hardware maintenance reference (712 pages) ,
- Maintenance information reference (595 pages) ,
- Problem determination manual (387 pages)
Table of Contents
Advertisement
o
Chapter 1. 3745 Models 210 to 61A: Connecting LlCs and
Cables
o
. 0
o
o
This chapter gives all the procedures for the 3745 (Models 210 to 61A) hardware
connection tasks. If this is the initial installation of your communication controller,
the following cabling order is recommended:
1. Plug in any Ethernet LAN access unit interface cables.
2.
Plug in any high-speed line cables
3. Plug in any token-ring cables.
4. Install cables for the operator console1, remote support facility2, any remote 2 or
alternate 2 console, and customer power control.
5. Install any line interface couplers or their cables.
Attention - - - - - - - - - - - - - - - - - - - - - - - - - ,
By touching inside the machine, you can cause electrostatic discharges (ESDs)
that may result in errors in the system operation, or damage to the equipment. .
Therefore, it is very important that you touch the ESD plate before you touch
any element inside a unit or before you plug in a cable. The ESD plate is
located on the inside face of the frame door .
1
LAN connection to the service processor in case of 3745 Models A.
2
This does not apply to the 3745 Models A.
©
Copyright IBM Corp. 1988, 1997
1-1
Advertisement
Table of Contents
