Installing Or Removing A Token-Ring Utp Cable And Media Filter - IBM 3745 Series Connection And Integration Manual

TIC3
Step 2
Plugging in an attachment cable
For this step, see Figure 3-5 on page 3-5.
Check that the cable is correctly labeled at both ends.
Push in the connector and tighten retaining screws.
Repeat this step for every cable to be plugged in.
When all token-ring attachment cables have been inserted, go to Step 7
on page 3-7.
Step 3
Unplugging a UTP cable
Ask the network operator to deactivate the UTP-connected line to be
removed.
Pinch the UTP cable connecter and pull it out. See IAI in Figure 3-6.
Shielded 8-Pin
Modular Connector
Unshielded Twisted-Pair
Cable Connector
Figure 3-6. Installing or Removing a Token-Ring UTP Cable and Media Filter
Step 4
Unplugging a Token-Ring UTP Media Filter
3-6
3745 All Models & 3746-900: CIG
Ask the network operator to deactivate the UTP-connected line to be
removed.
Loosen the retaining screws and pull out the media filter. See IB' in
Figure 3-6.
If you are only unplugging a UTP cable, go to Step 8 on page 3-7.
Otherwise, continue with the next step.
o
O · ~
. . . . . .
I
j