Festo CPX DE Series Manual page 89

3. Overview and connecting technology I/O modules
Fitting
Festo P.BE−CPX−EA−EN en 05602d
Fit the modules as follows (see Fig. 3/7):
Please note
Please observe the instructions on combining
·
I/O modules and sub−bases in section 3.2.2.
Please observe the instructions on combining and
·
arranging modules on the CPX terminal in the CPX
system manual.
Only in cases where the electronic module has been
removed:
Place the electronic module in the manifold sub−base.
·
Make sure that the grooves with the contact terminals on
the bottom of the electronic module lie above the contact
rails. Then push the electronic module carefully and with
out tilting as far as possible into the manifold sub−base.
Fitting the sub−base:
1. Align the sub−base over the manifold sub−base with the
electronic module. Make sure that the plug connectors of
the sub−base are aligned exactly with the connectors of
the electronic module. Then push the sub−base carefully
and without tilting onto the manifold sub−base.
2. Tighten the screws at first only by hand. Place the screws
so that the self−cutting threads can be used.
Tighten the screws with a Torx screwdriver size T10 with
torque 0.9 ... 1.1 Nm.
3−23